EEVblog Electronics Community Forum

General => General Technical Chat => Topic started by: Homer J Simpson on June 07, 2017, 06:51:49 pm

Title: Formlabs Fuse 1 SLS 3D Printer
Post by: Homer J Simpson on June 07, 2017, 06:51:49 pm

https://www.youtube.com/watch?v=IrFYt3uUdrI (https://www.youtube.com/watch?v=IrFYt3uUdrI)

Title: Re: Formlabs Fuse 1 SLS 3D Printer
Post by: Falcon69 on June 07, 2017, 07:15:33 pm

Nice.  I'm tempted. But $20k is quite abit.

Be better if they had more colors. Grey is just not gonna cut it.  I like the fact that you can use the parts right away without having to really do anything else to them.

Title: Re: Formlabs Fuse 1 SLS 3D Printer
Post by: CM800 on June 07, 2017, 07:24:37 pm

I believe you could affordably built one for approx 7-10k, you can buy YAG  laser / fiber lasers for a little below that.

Specifically, there are laser  engraver heads of around 30W or so that would be suitable.