General > General Technical Chat

Glue - safest to use on PCBs?

<< < (3/3)

coppercone2:

--- Quote from: maginnovision on August 11, 2020, 12:58:57 am ---Go2glue works as well, dries clear but is very conductive for a while as it dries. I've also used conformal coats as board adhesives but it can take a really long time to dry if you're not careful.

--- End quote ---

I like this one too, but keep in mind it contains benzeneish things. Excellent adhesive however. Not sure how benzene vapors effect electronics plastics either. I use it sparingly as strain relief.

https://echa.europa.eu/substance-information/-/substanceinfo/100.060.937

from a health stand point, it seems to stand up to its 'nice' smell. One of the only adhesives I like the smell of actually. Acrylic epoxies smell kind of ok (minty). Go2Glue is like menthol or something.

Not a skin or eye irritant; No evidence of skin sensitization in humans or guinea pigs; No evidence of reproductive or developmental toxicity; [ToxPlanet: EC: SCTEE] Not expected to cause adverse health effects; [Solutia MSDS] See "Dodecylbenzene."

Navigation

[0] Message Index

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod