General > General Technical Chat

Hakko 707 desoldering heater

(1/3) > >>

Wallace Gasiewicz:
Does anyone know of a source for the heater part of the Hakko 707 desoldering gun??
Or is there something that can be used instead of the original part? Perhaps another Hakko heater???

Wally

edavid:

--- Quote from: Wallace Gasiewicz on May 16, 2022, 07:05:28 pm ---Does anyone know of a source for the heater part of the Hakko 707 desoldering gun??
Or is there something that can be used instead of the original part? Perhaps another Hakko heater???

--- End quote ---

The Hakko 483 heater is the same (483-012 or 483-H-V12), but that doesn't help much since you can't find those either  :-//

Alex Eisenhut:
You're out of luck. I have a 707 as well and parts are not available since decades.

Alex Eisenhut:
...but maybe a few hours digging deep

https://www.aliexpress.com/item/32979065317.html

might give you something to try. I have no clue if that item works but it might be the start of a trail that leads you to a compatible part? I used the search terms "ceramic desoldering heater".

Wallace Gasiewicz:
Thanks for the replies
Alex's suggestion might actually work, it is about the correct wattage
The 707 does not have temp sensor...not a big deal
Will investigate further.
Drawings with dimensions might be helpful, don't see any dimensions on the Hakko manual drawings either.
However dimensions can't be too far off...or could they?
At this price might be worth a try.

https://www.manualslib.com/manual/1186329/Hakko-Electronics-707.html?page=7#manual

Navigation

[0] Message Index

[#] Next page

There was an error while thanking
Thanking...
Go to full version