General > General Technical Chat
hameg 203-6 scop the horizntal went left
(1/1)
oferfolk:
hi everyone
i have the 203-6 for over 30 years and it  worked fine and also look like new with no any rust
i just did not use it for a few years and i tried it and the line went left showing 2 cm and only can move more left and not to center.
it also the same with component and channels.
nothing is burn there. all look nice and clean.
i clean the switches and everything i could think of.
what else can i check ?
Greybeard:
Find the user manual in the web.
Check internal supply voltages and hum.
Check for overheated resistors, rectifires (or other components).
Check for leaking/blown electrolytic caps
Navigation
Message Index
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod