| General > General Technical Chat |
| High power LED damage reasons |
| << < (3/3) |
| floobydust:
It's an awful failure. The power supply might be slowww. You have to test it to really know. Although it has a fast CV spec, overload is 500msec and no specs exist for CC response time. Some power supplies screw up at the transition from CV->CC or CC->CV, either done slowly or lots of overshoot. Since the power supply can easily overpower the LED, I would have added a ballast resistor which can be (voltage) monitored to see if the PSU is well behaved. I would wonder if the LED thermal (paste and screw torque) was properly done. Were you getting decent heat transfer? Looking at Vf can give a rough estimate of LED temperature. |
| Navigation |
| Message Index |
| Previous page |