General > General Technical Chat
I can't stand seeing or using non-SMD parts. Am I sick?
<< < (3/9) > >>
bjdhjy888:
stencil?

 :horse:
 :scared:
Sal Ammoniac:

--- Quote from: bjdhjy888 on September 26, 2019, 01:29:04 am ---stencil?

 :horse:
 :scared:

--- End quote ---

Laugh it up fuzzball, but stencils save me loads of time.
tautech:

--- Quote from: Sal Ammoniac on September 26, 2019, 01:41:09 am ---
--- Quote from: bjdhjy888 on September 26, 2019, 01:29:04 am ---stencil?

 :horse:
 :scared:

--- End quote ---

Laugh it up fuzzball, but stencils save me loads of time.

--- End quote ---
Never bothered with them for prototypes or 'one off's'.

We each have or tricks for one off SMD work like tinning pads first, hold parts in place and reflow the pad with an iron then solder the other end and then finish the first pad.....done at least 4 in the time it took me to type this.
tautech:
The video in this post is a worthwhile watch and there's also some good SMD ideas throughout this thread:
https://www.eevblog.com/forum/beginners/so-surface-mount-it-is/msg1442590/#msg1442590
bjdhjy888:

--- Quote from: tautech on September 26, 2019, 01:59:21 am ---The video in this post is a worthwhile watch and there's also some good SMD ideas throughout this thread:
https://www.eevblog.com/forum/beginners/so-surface-mount-it-is/msg1442590/#msg1442590

--- End quote ---
Surface tension pulled the soder pasted onto the leads?
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod