General > General Technical Chat
I used to laugh at idiots ordering the wrong package size...
<< < (3/3)
Red Squirrel:
LOL I did a similar mistake.  Except I had dimensions and everything so it's 100% my fault.  I pretty much grossly underestimated just how small 5mmx5mm is when you are trying to dead bug solder it.  Pretty much need a PCB with proper solder pads for something like that.  I'm sure someone that's very good at soldering could dead bug it but it was a little beyond my skillet lol.
SilverSolder:

--- Quote from: blueskull on March 26, 2021, 01:40:31 pm ---And I always have a good laugh when idiots draw the wrong footprint, until I met this part.
Amazingly, it didn't blow up or short out the supply rail upon power on. I guess it has good DFI (design for idiots).
FYI, it's Bosch BNO055.

--- End quote ---

"Pin 1 II" ??  :D
thm_w:

--- Quote from: SilverSolder on March 26, 2021, 07:45:06 pm ---"Pin 1 II" ??  :D

--- End quote ---

"Pin 1 ID" in the datasheet.

Pin 1 is NC in the datasheet, so.. I assume the ID pad is NC as well but not really sure. Interesting choice, maybe it helps with pick and place bottom cameras?
Navigation
Message Index
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod