General > General Technical Chat

Is there a proper name for this particular cover/plug/pin/bung?

<< < (2/2)

SeanB:
Easiest is a tube of acrylic or silicone sealer, and wipe over the hole to leave a blob in the hole, and wipe after with a damp cloth. Fast, cheap, and works well.

Halcyon:

--- Quote from: SeanB on April 11, 2024, 07:54:15 am ---Easiest is a tube of acrylic or silicone sealer, and wipe over the hole to leave a blob in the hole, and wipe after with a damp cloth. Fast, cheap, and works well.

--- End quote ---

In this instance I want it to be removable.

I ended up finding something (which I hope works) listed under "Snap in locking hole plugs, rubber panel seal cover flush type panel round for kitchen rubber bulkheads waterproof sealing plugs" (read in Big Clive's voice).

EPAIII:
Rubber corks?

armandine2:
grommet gets used here

https://www.reevite.co.uk/grommets/blind




T3sl4co1l:
Brings to mind such as these,
https://www.mcmaster.com/products/hole-covers/protective-plugs~/
of course YMMV, you'll probably want to find your local equivalent as McMaster is fairly US-specific IIRC, but as a list of examples, that's fine.

Tim

Navigation

[0] Message Index

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod