General > General Technical Chat

Is this Wiring Legal? (NSW)

<< < (12/37) > >>

bdunham7:

--- Quote from: Labrat101 on December 06, 2020, 05:22:48 pm --- Where on This plate does it say Inverter

--- End quote ---

Why would it say 'inverter' on the inside unit?  |O

I didn't say that the word 'inverter' was on any of the placards.  Is it required to be?  What I did say is that the compressor unit is in fact an inverter-drive model and I'm not at all sure why you are convinced it isn't.

Labrat101:

--- Quote from: bdunham7 on December 06, 2020, 05:29:42 pm ---
--- Quote from: Labrat101 on December 06, 2020, 05:22:48 pm --- Where on This plate does it say Inverter

--- End quote ---

Why would it say 'inverter' on the inside unit?  |O

I didn't say that the word 'inverter' was on any of the placards.  Is it required to be?  What I did say is that the compressor unit is in fact an inverter-drive model and I'm not at all sure why you are convinced it isn't.

--- End quote ---
This from your Link     Why would it say 'inverter' on the  maybe some typed after ,
   this is from the page your link goes to were is the RED Inverter or the word   :-//

Monkeh:

--- Quote from: Labrat101 on December 06, 2020, 05:35:01 pm ---
--- Quote from: bdunham7 on December 06, 2020, 05:29:42 pm ---
--- Quote from: Labrat101 on December 06, 2020, 05:22:48 pm --- Where on This plate does it say Inverter

--- End quote ---

Why would it say 'inverter' on the inside unit?  |O

I didn't say that the word 'inverter' was on any of the placards.  Is it required to be?  What I did say is that the compressor unit is in fact an inverter-drive model and I'm not at all sure why you are convinced it isn't.

--- End quote ---
This from your Link     Why would it say 'inverter' on the  maybe some typed after ,
   this is from the page your link goes to were is the RED Inverter or the word   :-//

--- End quote ---

See attached screenshot of the site he linked..

Again, please show the diagram in the technical manual showing that the SRC35ZSA-W unit does not have an inverter drive.

coppercone2:
regulation aside, its a dumbass decision. As far as homes go an air conditioner is likely a
1) hard to service device, moreso then a oven. You can't pull it out of the cubby hole its in and unplug it
2) takes a while to get people to service it. A realistic house might require gardeners to cut their way into the overgrown HVAC and then a HVAC tech to say its fucked AFTER a deep all day clean then depending on your choice in system a shipping delay then an installation delay. (I am imagining full service in the worst case).

so it should be on its own breaker. I would do it that way.

The water pump is on a separate isolator because its a 4 day affair to change it if you got the money (well pump)
The stove is on a somewhat shared circuit because at most you blow the breaker and unplug it from the wall. This means 5 minutes on reduced lighting in a room with ~4 windows. But that light is like a work light when you are doing precise cutting and stuff in the kitchen (non chill).

I don't know why people are looking at regulation rather then the fact its not practical. They should make it practical for a home owner in case of contingencies.

I look at up time and safety. You cannot have lights going out and you don't want to tempt people to cook food improperly.

Monkeh:

--- Quote from: coppercone2 on December 06, 2020, 09:18:47 pm ---I don't know why people are looking at regulation rather then the fact its not practical. They should make it practical for a home owner in case of contingencies.

--- End quote ---

I looked at both. Not to mention the quality of the work.

The practicality is in fact a regulation (see my post on that..), but Dave wanted actual regulations to throw at them as opposed to an untrained customer saying "that's not how I think it should be".

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod