General > General Technical Chat
It Let The Smoke Out
(1/1)
DW1961:
I was tearing this old Antec PSU down and found why I think it hit the trash can. there was a daughter board attached to it. One of the corners of the board was literally smoked crispy, and a couple of the resistors were cracked.

I think this was a daughter board voltage regulator? Any ideas how or what went wrong? I put a couple of the fried 100 Ohm resistors on top of it just so you can see them in the image.

Navigation
Message Index
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod