General > General Technical Chat
Keysight 34465A saving temperature settings
(1/1)
Robaroni:
Hi,
Is there a way to save my temp settings on the 34465A so I don't have to redo them every time I use my probe?
Thanks for the time and help,
Rob
Dr. Frank:
Hi Rob,
that's easy.
Configure your 34465A to TEMP, and the sensor settings you need.
Then go to Utility - Store/Recall, select a name for your setting, and STORE STATE
Whenever you recall this state, it will exactly come up in this configuration.
You can also make this setting your default boot setup by storing the configuration and setting the DMM to "Power on - User defined". See manual for details, where /how to store this correctly.
Frank
Robaroni:
Thanks Frank, appreciated.
jonpaul:
Bonjour, A fantastic meter!
In Utility you can configure the startup to default to factory, user OR to restore previous
(SHIFT) Utility>>store/recall>>power ON
Selections ...
LAST
USER DEFINED
Factory Default
Suggest LAST
Same applies to entire series 34461A, 34470A etc.
Bon courage!
Jon
Navigation
[0] Message Index
Go to full version