| General > General Technical Chat |
| Looking for a project box to match this one |
| << < (3/5) > >> |
| cowasaki:
I’m developing a valve amp brick system. An input brick, bricks for 9 and 8 pin valves, a brick for tone stack, bricks with replaceable pots, a brick with breadboard, a reverb brick etc The idea is that you could hook together any idea for a valve amp in ten minutes and swap components in and out. These are finished 9 pin bricks and a tone stack brick (the pots are also switchable with different values and there is a bypass. The banana plugs are in, out and ground) |
| cowasaki:
All the bricks are the same size. The first is an octal brick but I’ve run out of the right octal valve sockets. That valve is just sat in the hole |
| Johnny10:
So like a plug and play guitar amp? |
| nali:
As it happens I have a near identical case sitting on a shelf gathering dust. It's slightly different to yours (vent holes) and a bit larger @ 300x200x75mm but you're welcome to it for postage. |
| jesuscf:
--- Quote from: cowasaki on March 02, 2020, 10:19:12 am ---That is the same box! Amazon will not send it to the U.K. and the American seller would cost me $50 plus when it came in they would charge me vat making it $60 and a £18 handling charge :-( Still need to find it in Europe but many thanks for spotting those. --- End quote --- I feel your pain! Found another source in USA: https://www.alltronics.com//cgi-bin/item/IC115B/10/10%22-(W)-x-7.4%22-(D)-x-3%22-(H)-Heavy-Duty-Desktop-Project-Box- Even if the shipping cost is high, they list the box for 12.95$. |
| Navigation |
| Message Index |
| Next page |
| Previous page |