General > General Technical Chat

Louis Rossman dont want to die, rights to repair Scientology E-Meter.

<< < (4/5) > >>

daqq:

--- Quote from: schmitt trigger on September 03, 2023, 03:06:30 am ---Inside however, was a completely different story. It was an absolutely unmitigated mess. Point to point wiring in terminal strips. I saw a few instances where wires or components were incorrectly connected or not connected anywhere else… they were only there to confuse and disguise.
--- End quote ---
Clearly they were beyond your understanding. The complex electronics are supposed to turn the bad money in the customer's pocket and through the miracle of Scientology turn it into good money in the "church's" pocket.

schmitt trigger:
I know, I know. I am not worthy.

These units employ unique fuzzy-linear Germanium Carbide ICs, to implement “no-pass filters” and “noise amplifiers”, which reject ALL the signals and only provide as an output distorted noise.

Brumby:
.... and here was me worrying about side-fumbling.

Boy, was I ever off the mark.   :palm:

floobydust:
I remember reading L. Ron was very particular about the E-meter dynamics. He was unhappy with a new model and totally redid the panel meter. Its ballistics, bobbing had to be just right because a certain wiggle means the alternate universe is communicating and you are not clear, there is a problem with your thetan.

Whoever designed this and what firm manufactures this, I believe the latest models are digital w/firmware, must be basking in his Lambo...

Gyro:
I'll never look at my Marconi TF2700 universal bridge the same way again! :scared:

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod