General > General Technical Chat

Maximum slew rate typically found in music/voice

<< < (14/14)

TimFox:
Slew rate is relevant to distortion, which may increase with signal level non-linearly.
Harmonic distortion and intermodulation distortion are different ways to quantitatively measure the same non-linear behavior.
3rd-order intermodulation products will not be affected by a low pass filter, since they are close to the two test-tone frequencies.
Bandwidth is a measure of a linear system.

tggzzz:

--- Quote from: strawberry on September 23, 2023, 05:20:23 pm ---slewrate is bandwidth

--- End quote ---

Slewrate is bandwidth plus amplitude.

There is a reason that bandwidths are often divided into two distinct categories: "small-signal bandwidth" and "full-scale bandwidth". The former is where slew rate limiting doesn't occur.

TimFox:
The latter is often called “full-power” bandwidth on data sheets.

tggzzz:

--- Quote from: TimFox on September 24, 2023, 09:12:06 pm ---The latter is often called “full-power” bandwidth on data sheets.

--- End quote ---

Sigh. Quite right.

Brain failure on my part; shouldn't post when too tired.

Navigation

[0] Message Index

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod