General > General Technical Chat

Mods are asleep, post EEVmemes

<< < (55/60) > >>

I wanted a rude username:

I wanted a rude username:

tom66:

--- Quote from: daqq on December 08, 2021, 09:05:27 am ---Guess the software.

--- End quote ---

Vivado when spending 15 minutes synthesising my design only to tell me I have a DRC error before going onto the multicore implementation?

Or am I just bitter?

timenutgoblin:

--- Quote from: I wanted a rude username on February 06, 2022, 09:46:28 pm ---...snip...

--- End quote ---

What is the story regarding the poor quality solder joints and alignment of some of the SMD components? Is that related to the meme?

I wanted a rude username:
The appearance of this potentiostat PCB is explained by the fact that Dryden used the popular "solder paste without a stencil, followed by extensive rework" technique.  ;D  But anything beyond a punny bear may be reading too much into it.

https://microfluidics.utoronto.ca/gitlab/dstat/dstat-hardware/-/wikis/home

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version