Author Topic: Need N Connector "gasket"  (Read 798 times)

0 Members and 1 Guest are viewing this topic.

Online xrunnerTopic starter

  • Super Contributor
  • ***
  • Posts: 7836
  • Country: us
  • hp>Agilent>Keysight>???
Need N Connector "gasket"
« on: January 21, 2022, 05:17:31 pm »
I need some of the rubber gaskets shown in the pic for N connectors. Cannot locate a supplier for the gasket only. Please advise if you know of a source of these gaskets.

Thanks in advance.
I told my friends I could teach them to be funny, but they all just laughed at me.
 

Offline Sal Ammoniac

  • Super Contributor
  • ***
  • Posts: 1764
  • Country: us
"That's not even wrong" -- Wolfgang Pauli
 

Online xrunnerTopic starter

  • Super Contributor
  • ***
  • Posts: 7836
  • Country: us
  • hp>Agilent>Keysight>???
Re: Need N Connector "gasket"
« Reply #2 on: January 21, 2022, 06:13:18 pm »
Is this what you're looking for?

https://www.americanradiosupply.com/large-silicone-gasket-washer-for-uhf-and-type-n-bulkhead-connectors/

Sal - it doesn't appear so. Those are for bulkhead connectors and it looks like it goes between the connector and the chassis. The ones I want go inside the N connector.
I told my friends I could teach them to be funny, but they all just laughed at me.
 

Offline Sal Ammoniac

  • Super Contributor
  • ***
  • Posts: 1764
  • Country: us
Re: Need N Connector "gasket"
« Reply #3 on: January 21, 2022, 06:52:34 pm »
Your best bet might be to buy a whole N connector and remove the gasket.
"That's not even wrong" -- Wolfgang Pauli
 

Offline jpanhalt

  • Super Contributor
  • ***
  • Posts: 4002
  • Country: us
Re: Need N Connector "gasket"
« Reply #4 on: January 21, 2022, 07:24:17 pm »
Since you will need to remove the gasket to replace it, why not just measure and make your own from a suitable material, like silicone rubber?
 


Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo
Smf