General > General Technical Chat
Non-contact approach for measuring AC VAC/I and PF
bsodmike:
Any suggestions for the above? Galvanic isolation or non-contact with Current transformers.
Safety first as this will go into my main breaker box. I will be interfacing a custom STM32 solution and/or Raspberrpy Pi
Also power draw W / VA measurements will need to be processed.
Thanks so much.
Kind regards
Mike
NiHaoMike:
https://openenergymonitor.org
S. Petrukhin:
--- Quote from: NiHaoMike on May 15, 2024, 12:25:42 pm ---https://openenergymonitor.org
--- End quote ---
Do you trust Arduino firmware? :)
NiHaoMike:
--- Quote from: S. Petrukhin on May 15, 2024, 12:33:35 pm ---Do you trust Arduino firmware? :)
--- End quote ---
Why not? None of the firmware is doing anything safety critical.
S. Petrukhin:
--- Quote from: NiHaoMike on May 15, 2024, 01:38:00 pm ---
--- Quote from: S. Petrukhin on May 15, 2024, 12:33:35 pm ---Do you trust Arduino firmware? :)
--- End quote ---
Why not? None of the firmware is doing anything safety critical.
--- End quote ---
People who use Arduino are not a reliable source of code for me personally.
Professionals use other means. :)
Navigation
[0] Message Index
[#] Next page
Go to full version