General > General Technical Chat
Not being able to test 82c55a
gkmaia:
Having a hard time to test a 82c55a.
I am following the truth table but I can only send data from the ports to the data bus. And not being able to send the data from data bus to ports.
I am attaching A0,A1,CS,RD & WR directly to gnd OR VCC as required by the table and sending 5v pkpk signals from and to ports/bus.
What am I missing here?
MK14:
What about the RESET pin ?
DrG:
--- Quote from: gkmaia on August 02, 2020, 09:39:36 pm ---Having a hard time to test a 82c55a.
I am following the truth table but I can only send data from the ports to the data bus. And not being able to send the data from data bus to ports.
I am attaching A0,A1,CS,RD & WR directly to gnd OR VCC as required by the table and sending 5v pkpk signals from and to ports/bus.
What am I missing here?
--- End quote ---
Have you reviewed the modes and set them as you intended and using the correct ports for the mode? https://ekoharsono.files.wordpress.com/2012/10/5-82c55-programmable-peripheral-interface1.pdf?
[*dayam* I have not thought about that chip in many years.]
gkmaia:
Yes. I am using it as Mode 0 port A B or C. CS A0 and A1 LOW.
I am not going down A0 and A1 HIGH and using the control register.
Just basic data to and from ports flow.
RESET pin is LOW. But it actually does not make a difference when I change it.
DrG:
circuit? code?
Navigation
[0] Message Index
[#] Next page
Go to full version