General > General Technical Chat
Old T&M Gear - ever wondered how they get those component bends?
(1/1)
Tony_G:
Hey All,

I just stumbled across this video that shows what a typical manufacturing experience would have been for that old test gear - I have many pieces of gear that have these "perfect" bends in transistor etc, if you've worked on that old gear you would have seen it as well.

I thought it was worth sharing:



I would be remiss if I didn't take the opportunity to point out that the title is also an accurate summation of my entire career...

TonyG
coppercone2:
if you don't have them, get wire bending pliers. They make doing a nice job so much easier.

For real precision get a box of drill blanks so you can wrap any size loop

I have been meaning to buy a very fine tip marker so I can mark bend areas on leads too
Navigation
Message Index
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod