General > General Technical Chat
OT: Any woodworkers here?
<< < (8/9) > >>
Alex Eisenhut:
Cool, I found my hobby plane, I'll start this afternoon and let you know in a couple of months how far I get.  :=\
madires:
Ouch! :scared:
tautech:

--- Quote from: Alex Eisenhut on December 04, 2020, 07:02:16 pm ---Cool, I found my hobby plane, I'll start this afternoon and let you know in a couple of months how far I get.  :=\

--- End quote ---
:-DD
Like pissing into the wind !  :box:

Get the grinder and sanding pads out if you require real progress.
coppercone2:
don't use the grinder on wood, its too easy to burn it and get black / charcoal spots. You just don't need those kinds of RPMs.  Same with flapwheel I think unless you are very careful doing touch up.
tautech:

--- Quote from: coppercone2 on December 04, 2020, 07:49:39 pm ---don't use the grinder on wood, its too easy to burn it and get black / charcoal spots. You just don't need those kinds of RPMs.  Same with flapwheel I think unless you are very careful doing touch up.

--- End quote ---
Balderdash !  :bullshit:
Stripped the paint off my old house with 5" and 7" sanding pads and smoothed with a rotary orbital and 40 grit.
9" grinder for the large areas and the 5" for the more delicate/confined areas.

Until you've done it you couldn't know.  ;)
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod