General > General Technical Chat
OT: What state am I in?
<< < (14/15) > >>
S. Petrukhin:

--- Quote from: JohnnyMalaria on January 11, 2021, 02:49:20 pm ---Yay!

Now, will it work? (The PCB, not the free holder :) )

It took 3 days 5 hours from FedEx pick-up to delivery.

--- End quote ---

Congratulations!  :)
Ed.Kloonk:
All this and now we find there's a goof on the pcb.


 :scared:
JohnnyMalaria:

--- Quote from: Ed.Kloonk on January 11, 2021, 11:26:38 pm ---All this and now we find there's a goof on the pcb.


 :scared:

--- End quote ---

Well, so far, so good. The power section works okay. I'm going to put the chips in tomorrow a section at a time. Hopefully, by the end of the week I will have compared it to the existing board it's replacing.

This is my first PCB. I used Eagle and hated it but that's what I sent to JLCPCB. I learned KiCAD in a day to do the 3D. I have to say I definitely prefer KiCAD. My god, it's free and to get 5 boards for $25 in a week is dumbfounding to me.
S. Petrukhin:
Funny: KiCad draws connectors with mounting caps in a 3D model. :)

JohnnyMalaria, I wish you 100 more PCBs and that they were all without goof the first time.  :)
JohnnyMalaria:

--- Quote from: S. Petrukhin on January 12, 2021, 07:03:37 am ---Funny: KiCad draws connectors with mounting caps in a 3D model. :)

JohnnyMalaria, I wish you 100 more PCBs and that they were all without goof the first time.  :)

--- End quote ---

The connector models are from the manufacturer. The reason I gave up on Eagle was the nightmare of the "integration" with Fusion 360 and the painful, repetitive steps to go through to put in a new model.
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod