General > General Technical Chat
PC1602K-P9 LCD pinout
(1/2) > >>
jdev99:
Can any body help me with the pinout for this display please?
It is a "POWERTIP" PC1602K-P9 module (16x2 characters), based on a S6A0069 controller, which is similar to the HD44780.
It is from an old network switch

I traced out what I can, see attached schematic and photos.

Thank you for any assistance.
amyk:
If you have the device it came from, and a scope or logic analyser, you can find out the remaining pins. It's probably being used in 4-bit mode judging by the number of pins left over on your schematic.
kjr18:
Hi, I found this datasheet, it might be what you're looking for: datasheet link here.
jdev99:
That is the one, thank you very much.  :-+ :)
How did you find it, if I may ask?
kjr18:
First I tried searching for "pc1602k-p9" then on images I found some photos from this page. Last post contains dead link to datasheet, but provides another parts number that shows what you look for.
Navigation
Message Index
Next page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod