« previous next »
Pages: [1]   Go Down

Author Topic: PCB assembly jigs-Any recommendations?  (Read 4893 times)

0 Members and 1 Guest are viewing this topic.

Offline djsbTopic starter

  • Frequent Contributor
  • **
  • Posts: 980
  • Country: gb
PCB assembly jigs-Any recommendations?
« on: June 13, 2010, 04:14:19 pm »
Hi,
Does any one have any suggestions for a reasonably priced (around £50-will pay more for quality) PCB assembly jig. I mainly work on eurocard (100mm x 160mm) sized pcb's but if I can buy something that takes bigger even better. It's mainly for prototype use.
Thanks.

David.
Logged
David
Hertfordshire, UK
University Electronics Technician, London, PIC16/18, CCS PCM C, Arduino UNO, NANO,ESP32, KiCad V8+, Altium Designer 21.4.1, Alibre Design Expert 28 & FreeCAD beginner. LPKF S103,S62 PCB router Operator, Electronics instructor. Credited KiCad French to English translator
 

alm

  • Guest
Re: PCB assembly jigs-Any recommendations?
« Reply #1 on: June 13, 2010, 07:31:29 pm »
There was a topic about it recently, might contain some helpful info.
Logged
 

Offline saturation

  • Super Contributor
  • ***
  • Posts: 4787
  • Country: us
  • Doveryai, no proveryai
    • NIST
Re: PCB assembly jigs-Any recommendations?
« Reply #2 on: June 14, 2010, 01:23:38 am »
Can't go wrong with a Panavise



But for small PCB and general use I find the elcheapo 'helping hands' more than adequate:



In the USA, China clones are only $5.
Logged
Best Wishes,

 Saturation
 

Offline cybergibbons

  • Frequent Contributor
  • **
  • Posts: 400
Re: PCB assembly jigs-Any recommendations?
« Reply #3 on: June 14, 2010, 09:10:35 am »
I love my Panavise - unfortunately they are very overpriced in the UK. Keep an eye out on Ebay.
Logged
 
Pages: [1]   Go Up
« previous next »

Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo
Smf

 


EEVblog Main Site EEVblog on Youtube EEVblog on Twitter EEVblog on Facebook EEVblog on Odysee