General > General Technical Chat
programmer for lattice mach211sp
(1/2) > >>
oggie:
I need to program a couple of mach211 chips, so I don't really want to invest in an expensive programmer for just a few chips.

I have a tl866-II and a superpro 610. As well as a few jtag usb based programmers. Even if I got a plcc to dip adaptor, the software for those programmers don't seem to have support for these lattice chips.

I also see there's an adaptor for the hi-lo programmer : https://github.com/nobodyisinocent/ADP-Mach-for-HiLo but I don't have the all-03 programmer. 

Any suggestions?
KG7AMV:
Did you ever get them programmed? I can do that chip with my Xeltek Superpro 6100N and 7500

KG7AMV:
Noticed the 6100N don't support the SP some times it don't matter but the Superpro 7500 supports the SP. If you just have a hand full that need to be programmed I would be more then happy to help ya out. Right now 60+% of my business is programming chips and if it's not under NDA = youtube content. I think I still have a PLCC44 adapter. I don't run across PLCC's often any more. 





oggie:
Thanks for the offer. I ended up buying the chips from a source that can also program them for me, so I used that service.

shift838:

--- Quote from: oggie on October 13, 2023, 01:04:37 pm ---Thanks for the offer. I ended up buying the chips from a source that can also program them for me, so I used that service.

--- End quote ---

I am in need for the same programming on the same chip.  Who did you use to purchase the ICs and have them programmed?

Navigation
Message Index
Next page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod