General > General Technical Chat

programmer for lattice mach211sp

(1/2) > >>

oggie:
I need to program a couple of mach211 chips, so I don't really want to invest in an expensive programmer for just a few chips.

I have a tl866-II and a superpro 610. As well as a few jtag usb based programmers. Even if I got a plcc to dip adaptor, the software for those programmers don't seem to have support for these lattice chips.

I also see there's an adaptor for the hi-lo programmer : https://github.com/nobodyisinocent/ADP-Mach-for-HiLo but I don't have the all-03 programmer. 

Any suggestions?

KG7AMV:
Did you ever get them programmed? I can do that chip with my Xeltek Superpro 6100N and 7500

KG7AMV:
Noticed the 6100N don't support the SP some times it don't matter but the Superpro 7500 supports the SP. If you just have a hand full that need to be programmed I would be more then happy to help ya out. Right now 60+% of my business is programming chips and if it's not under NDA = youtube content. I think I still have a PLCC44 adapter. I don't run across PLCC's often any more. 





oggie:
Thanks for the offer. I ended up buying the chips from a source that can also program them for me, so I used that service.

shift838:

--- Quote from: oggie on October 13, 2023, 01:04:37 pm ---Thanks for the offer. I ended up buying the chips from a source that can also program them for me, so I used that service.

--- End quote ---

I am in need for the same programming on the same chip.  Who did you use to purchase the ICs and have them programmed?

Navigation

[0] Message Index

[#] Next page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod