General > General Technical Chat
quick way to straighten ANY wires.
Martin Miranda:
SilverSolder:
Clever - I like it! :D
RoGeorge:
He, he! :-+
jpanhalt:
BS. It's a breadboard. The wires do not need to be perfectly straight. Copper work hardens as do most metals, which means bending it back to its original is almost impossible. Probably the ends have already been bent to fit in the holes. How do you roll them? Just use your fingers, If you're a tool junkie, get a pair do duck bill pliers or "hand seamer."
Martin Miranda:
--- Quote from: jpanhalt on January 13, 2022, 10:09:18 pm ---BS. It's a breadboard. The wires do not need to be perfectly straight. Copper work hardens as do most metals, which means bending it back to its original is almost impossible. Probably the ends have already been bent to fit in the holes. How do you roll them? Just use your fingers, If you're a tool junkie, get a pair do duck bill pliers or "hand seamer."
--- End quote ---
:-+ K.
Navigation
[0] Message Index
[#] Next page
Go to full version