General > General Technical Chat
Recommendation for an Air -> Liquid Head exchanger?
<< < (4/6) > >>
Lord of nothing:
@BrokenYugo
You are right. I try to search on Ebay and found some stuff:
https://www.ebay.at/itm/384286652522




The big Pipe is for the Air and the small for the Water right?

Edit here is my Heater:
https://ae01.alicdn.com/kf/H19fd202791f24a9085f6ae6cf2113b00w.jpg
On the Bottom is the Air intake and exhaust.
Lord of nothing:
So I order some exhaust heat exchanger. I am a little worried how to connect them to the exhaust Pipe. Is there some flexible Pipe on the Market who withstand the Hight Temperatures and can be Shield with Insulation?
Lord of nothing:
So everyone.
Today the arrived here yes I got 2 of them since the Seller have 2 in Stock for a good price.
The are "the big one". I found that the Company made many different Models of that Heat exchanger.
When I see, know,... that the not ectract all the Heat who come out of the exhaust a bigger is maybe better.
G7PSK:
For exhaust heat recovery you would be better of with a tube heat exchanger, plate types tend to clog up easily. Well that is my experience of them, I used to make essential oil distillation equipment back in the late 90's and plate exchangers were constantly needing to be taken apart for cleaning whereas tube type exchangers did not need cleaning as often and when they did it was a simple job of removing one end and running a brush through the tubes, plates need a gasket between every plate and both the hot and cold side are held together by the same fasteners. Plate coolers are much more efficient but sometimes that is not always best.
Lord of nothing:
Hi
I bought 2 "AGR Cooler" who are strait Tubes inside. I just need to wait until the Heater arrive.  :=\
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod