General > General Technical Chat
Roland "DXG-1100" pen plotter
sbrito:
hello, can someone help me in finding the drivers for my HP7475A (actually is a SEKONIC SPL450)?
Thank You
dm9876:
Hi all, only reviving this old thread in case some people were following it.
Anyway, I have an old Roland DXY-1200 A3 size flat bed pen plotter which I need to get rid of. (downsizing the house).
1200 is the same as this 1100 (there was also a 1300 I think) they only differ by the amount of buffer memory, which was important back when driving these things from a single tasking dos computer and you wanted to download the plot and then use the computer to keep working on something else.
I had planned to do the same thing mentioned here about plotting onto copper clad board with a marker pen as an etch resist. I never got around to it.
It could also make a good xy bed for a quick conversion to low power laser engraver.
Happy to let it go for a nominal amount (~$20 Australian) if someone is prepared to pick it up. (I'm at Berowra Heights in the north of Sydney)
Dean
tautech:
Welcome to the forum.
About your location...... :rant: :rant: :rant:
I'd grab in an instant if I was near you. Bugger :'(
mikeselectricstuff:
I have a DXY-1100 if anyone in the UK is interested - collection only (Loughton, Essex)
Delta:
That is incredibly cool!
Never mind new pens, stick a Dremmel in there and engrave your own boards!
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version