General > General Technical Chat
Sharing some project planning phase: A (digital) ELECTRO-MECHANICAL Network
<< < (10/39) > >>
RJSV:
Here is photo of next phase, box number three, actually...
   Previous box gives model, for exact panel sizing, that's always a pain.  Things like which panel overlaps the other two, etc.
Each segment has 1/3 the whole, as a book shaped compartment. That's 2 inches depth, giving roughly 1 inch for inputs and 1 inch (depth) for outputs.
In photo, see the 'stairstep' arrangement, 'A' outputs at the highest, of the 3.
RJSV:
The advantage, this box layout has simple, one behind the other. By offset downward (1 1/8 inches) there can be 3 separate segments or sections, 'A', 'B', 'C, all fit within 7 inch height.
RJSV:
   In photo, I wanted to point out, the 3 'music boxes' that are shown side-view.  The stair-like arrangement puts the 'A' segment up higher, and in front.
The 'C' compartment is on the (photo) left. The two horizontal panels are the 'floor' for each separate compartment: floor is for each so-called 'half-wall'.
RJSV:
In this photo view, is another version, of the Rotary Switch: this one, perhaps, more suitable for miniaturization. That is called a 'SLEEVE SWITCH' and involves coordinated movement, with sleeve sliding on-off, and with a flexing or shifting of the drive (cable).
RJSV:
Here is a nice, 'Christmas-y' color photo: the green compartment is like 'START' or SET on a flip/flop.
The red is for clearing or 'RESET' as a process
The blue, that's for what ever the application wants, using the one dedicated output shaft ('C').
That's also called the local output shaft, or 'Virtual Motor', that being addressable.
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod