General > General Technical Chat
Show your favorite and most used benchtop PSU
BFX:
Also second HP 6632B upgraded to front terminals :)
Is little pity that I haven't original HP banana terminals but it's enough.
ketil b:
--- Quote from: BFX on March 20, 2016, 07:19:18 pm ---Also second HP 6632B upgraded to front terminals :)
Is little pity that I haven't original HP banana terminals but it's enough.
--- End quote ---
I have found these which a pretty close.
rdl:
There is at least one other ebay seller that has the gray binding posts with 5 different ring colors including green. The only problems I've found is that the gray color is a bit to the brown side which doesn't look so good with some equipment, and the posts are not cross drilled.
BFX:
--- Quote from: ketil b on March 20, 2016, 09:55:58 pm ---
--- Quote from: BFX on March 20, 2016, 07:19:18 pm ---Also second HP 6632B upgraded to front terminals :)
Is little pity that I haven't original HP banana terminals but it's enough.
--- End quote ---
I have found these which a pretty close.
--- End quote ---
It's nice but I don't believe this Chinese products :) I would prefer used original connectors 8)
Modified: By the way put to the e-shop example broken piece (see picture) is unacceptable :--
Macbeth:
--- Quote from: rdl on March 20, 2016, 10:31:16 pm ---There is at least one other ebay seller that has the gray binding posts with 5 different ring colors including green. The only problems I've found is that the gray color is a bit to the brown side which doesn't look so good with some equipment, and the posts are not cross drilled.
--- End quote ---
I did my HP 6632B front panel with the 5 colour ones. I had to use ALL of them for sense, earth, etc :-+
Grey colour seems spot on to me. Lack of drill hole really hasn't been an issue - except when I stupidly tried to melt some wire which worked perfectly including embedding itself in the red output ring! :-DD
Oh, of course I had to do the faceplate graphics to stop that space being so wasted and ugly. I just printed on to some laser OHP acetate I had and stuck on with sellotape. I've actually got some sheets of water transfer paper to do a more professional job but I have better things to do now I got bored of pimping my 6632B ;D
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version