General > General Technical Chat

Show your favorite and most used benchtop PSU

<< < (92/99) > >>

jayjr1105:
My one and only, homebrew.  12V5A switching supply with LTC3780 doing all the magic.

GeorgeOfTheJungle:
Up to 350W, pure chinesium inside, works wonderfully:

mrjoda:
I build this maybe 6 years ago and it is my No.1 from then. Keithley 2302 and Phillips 2811 are nice, but they are collecting dust on my desk most of the time. Outputs: 25V/1,5A regulated and +/-3V3; +/-5V; +/-12V unregulated/switchable. Linear, robust, low noise and fast enough...

nardev:
[ Specified attachment is not available ] [ Specified attachment is not available ]Not the best in the wold but exactly what i needed : ) small and stable enough. RIDEN RD6006.

Good thing to mention, they were very prompt in email support. I couldn't figure out few things at first.

p.s. i did some customization, didn't like the switch and i only needed this small PSU

SteveyG:

--- Quote from: nardev on December 12, 2019, 01:32:49 pm --- (Attachment Link) (Attachment Link) Not the best in the wold but exactly what i needed : ) small and stable enough. RIDEN RD6006.

Good thing to mention, they were very prompt in email support. I couldn't figure out few things at first.

p.s. i did some customization, didn't like the switch and i only needed this small PSU

--- End quote ---

Where's your mains earth??

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod