| General > General Technical Chat |
| Show your favorite and most used benchtop PSU |
| << < (94/99) > >> |
| MarkF:
I have been hooked on these little supplies since my college days. Currently, I have three of them and a fourth 60V model. |
| Mr Evil:
--- Quote from: BravoV on December 28, 2019, 04:13:28 pm ---Congratz on your 1st post, and welcome to the forum. :clap: --- End quote --- Thanks. I don't know why I didn't join this place years ago. |
| artag:
I have a few of these Lambda supplies in various ranges. They're quite small, at least in panel space : 4 will fit in a 19" rack frame. Amazingly, the first two I bought were from a normal car boot sale (not an amateur radio one .. just the usual clothes and attic junk, and these lovely power supplies). I wish I could get some more coaxial knobs to fit them, though - most have that cover over the output voltage control (right hand supply) instead. Preferably to match the current limit control, I'm fussy like that. A tip if you have one of these to repair and need to replace the Lambda-marked 'special' regulator IC. It's a Motorola MC1566L. Although I also have some HP and Farnell supplies with higher ratings or better precision, I use this one more than anything : it deals with the majority of needs and, most important of all, it has no fan. I do have a couple of home-made ones as well (built while I was at high school). They still work but don't have meters though so are less convenient to use. |
| Wolfgang:
Hi, my first (1978) was a homebrew linear PSU 2-30V, 1.5A using a standard LM723 circuit with current limiter and analog meter. Big heatsink, no fan, selfmade PCB. Now, my default PSU is the Rigol DP832A (2x30V/3A, 1x5V5A). Same as Dave. For super sensitive stuff (ULN crystal oscillators) I use Keysight SMUs (B2962A). High voltage PSUs I made from scratch (e.g., 250V/150mA, 500V/30mA, ...) https://electronicprojectsforfun.wordpress.com/power-supplies/high-voltage-lab-power-supplies/ For my other projects, I normally prefer homemade standard PSUs using either LM723 or TL431 regulators. I dont like the LM78XX and LM317 series parts too much because of more noise and many counterfeit parts. |
| jogri:
My most used PSUs are those two linear Oltronix B703DT. A joy to work with, but a PITA to disassemble since there is virtually no space left unused on the inside (Marco Reps did a video on his unit if you want pictures of the inside, i am not going to open mine [btw, you can tear them down rather easily, but he somehow didn't figure out how]). The PSU on the top is still waiting for its upgrade to safety banana plugs, i am kind of hesitant to open it again. They are relatively compact (roughly 20x20x20 cm) and feature three galvanically isolated channels each, so you can stack the outputs together to get a 100V 0.6A supply. |
| Navigation |
| Message Index |
| Next page |
| Previous page |