General > General Technical Chat
T-shirt designs for anyone in to electronics
ElectronicSupersonic:
--- Quote from: NivagSwerdna on April 05, 2019, 03:45:11 pm ---How about... Easily LED? :)
I can't say I personally fancy any of those but I think you are getting somewhere... Good Luck!
--- End quote ---
Thanks for the input! "Easily LED" is certainly better then WLED (don't want to be accused of racism or anything like that). :)
ElectronicSupersonic:
Content removed due to violation.
ElectronicSupersonic:
Fun (hopefully) continues. 8)
Duracell themed design.
tooki:
--- Quote from: ElectronicSupersonic on April 04, 2019, 03:30:09 pm ---
--- Quote from: mikeselectricstuff ---Except that it's wrong - you should not clean your tip on the way in...
--- End quote ---
It depends on how properly it was cleaned previously. I always tend to find some residues. Probably my wool should be changed.
--- End quote ---
Huh? Mike means that you should never clean the tip when returning it to the stand. Which is correct — you want to leave the solder on the tip when idle, not wipe it off. Clean it only just BEFORE use, not after.
Ice-Tea:
One with a DC source and diode: "You Shall Not Pass" ;)
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version