| General > General Technical Chat |
| The Rigol DS1052E |
| << < (65/166) > >> |
| flolic:
--- Quote from: Dynomo on March 18, 2010, 09:12:37 pm --- I was swapping back and forth between 100mhz to 50mhz doing some testing and accidently left the E off the model number and the scope still booted up fine to my surprise. I never noticed I have left the E off the model number until I looked at the scope wondering why the model number was wrong :) It fired up with DS1102 as 100mhz ok luckily. --- End quote --- What makes me think, maybe we should try to rename the scope as DS1152E or DS1202E and get even more from it ;D |
| flolic:
--- Quote from: rf-loop on March 19, 2010, 05:20:39 am --- I ask becouse there is something wrong! there is minimum 3 posibilities: 1. Test configuration is bad? (bad cable/missing or fail termination.) 2. Your oscilloscope is fail. (not my first opinion becouse both channels equal) 3. Signal generator is fail. (leveling defect) --- End quote --- My vote goes for a number 1 ;) |
| JimBeam:
--- Quote from: flolic on March 19, 2010, 06:51:44 am ---What makes me think, maybe we should try to rename the scope as DS1152E or DS1202E and get even more from it ;D --- End quote --- Or maybe 1204D, and suddenly two additional BNC and a SCSI like connector blossom up on the front ;D ;D |
| flolic:
--- Quote from: Mark_O on March 18, 2010, 04:31:17 am ---P.S. BTW, I wanted to say "thanks" for those exceptional detailed photos you did of the Rigol internals. The combined panoramic shots were phenominally good, and extremely well lit. Really amazing. Thanks! --- End quote --- Haha, I tried my best :) Also, I am sure that you would not believe me when I tell you that only lighting was from my flashlight ;D |
| flolic:
--- Quote from: JimBeam on March 19, 2010, 07:01:55 am --- Or maybe 1204D, and suddenly two additional BNC and a SCSI like connector blossom up on the front ;D ;D --- End quote --- Mmmm, I definitely have to try that ;D |
| Navigation |
| Message Index |
| Next page |
| Previous page |