General > General Technical Chat
The Rigol DS1052E
alm:
Seems like the Agilent DSO1000 is more like the Rigol DG1000A/B series, but I wouldn't expect them to change the protocol at every revision.
The Agilent service manual only contains the performance check, however, so it's not much help (although completing the performance check would be a start). No calibration info, not even a simplified block diagram of the system. I'd be quite disappointed if I paid Agilent serious money for this.
I'd be careful to start any calibration routine without proper documentation, even if you could reverse-engineer or guess the commands. You don't know what signals the scope expects, and what the requirements are. What if the first step is erasing any previous calibration data? The actual knowledge that it will meet its specs is probably you only get buy buying an actual DG1102E.
Grapsus:
I just got my DS1052E from dealextreme :
- 390$
- ordered on 4/23, shipped on 4/28 and received on 5/6 which seems good, I only paid 15$ extra to get EMS shipping
- the certificate says it was manufactured on 4/20
- firmware was 00.02.04
- I went back to 00.02.02 SP2, did the hack and returned to 00.02.04 (got files from rcgroups)
Thank you guys! This scope is awesome :D
cqmiao:
My ds1052e version is 00.01.03,can it to change 100MHZ?
GeoffS:
--- Quote from: cqmiao on May 08, 2010, 02:35:06 am ---My ds1052e version is 00.01.03,can it to change 100MHZ?
--- End quote ---
I'd upgrade the firmware to 00.02.02 SP2 as this one is known to work.
cqmiao:
Could you send me a 00.02.02 SP2 firmware?
my email : cqmiao@hotmail.com
THANKS~
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version