General > General Technical Chat
The Rigol DS1052E
tequipment:
It will be a bit but I am working hard on it! Stay tuned.
halman:
Hello,
I seem to have bricked my scope while performing the firmware downgrade… When I restart the scope it does not boot up but one can see that the lcd is turned on but there is no image…
Any tips, can I somehow trigger a reflash from this state?
I have access to the necessary equipment to desolder and reflash most types of memories in a programmer .. but i rather not if there is any other way…
Mechatrommer:
what happened? incomplete downgrade? blackout?
u said you can reprogram the spansion? well, i need one good spansion with rigol ds1052e firmware inside... if you can help.
i hope there is a way to reflash through usb or rs232 serial port, or even jtag header inside it? ???
halman:
It must have been an incomplete flash. I inserted an usb stick with the firmware and ran it from the menu system, once it was done I restarted the scope, it was then it refused to start up properly. Strange things go on with the button lights they light up randomly and if i do quick restarts they move...it looks kinda like a counter is incrementing.
spansion?
I can reprogram flash memories and eeproms easily enough, if i have to. But I don't know which parts of the .rgl file to place where.. and in what order ...
dimlow:
Im still watching this thread with interest, i doubt anybody will come up with a solution to this problem.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version