General > General Technical Chat
The Rigol DS1052E
<< < (154/166) > >>
Dago:

--- Quote from: mxmxmx on December 14, 2010, 08:43:32 am ---
--- Quote from: Dago on December 13, 2010, 01:41:33 pm ---Can anyone give me any pointers on how to use the ":WAVEFORM:POINTS:MODE MAXIMUM" mode?

I've tried this (in code): stop the scope -> set ":WAVEFORM:POINTS:MODE MAXIMUM" mode -> run scope -> wait for trigger status change to triggered -> stop scope -> get data. But I still get just 600 points of data. What am I doing wrong?

--- End quote ---

Use the single shot mode.

--- End quote ---

I just figured out this myself but thanks :)
n3wbie:
Does this 50 to 100MHz hack still work with the newer Rigol? DS1052E's?
Crippled:

--- Quote from: n3wbie on December 14, 2010, 03:43:09 pm ---Does this 50 to 100MHz hack still work with the newer Rigol? DS1052E's?

--- End quote ---
I ordered mine December 1st at DX, when I receive it, I'll place it here if it is possible to hack or has the 02.05 version.
n3wbie:
Are you the same "Crippled" as on the dx forum?

http://www.dealextreme.com/forums/Forums.dx/Forum.-202~threadid.764985


--- Quote from: NAND74 ---I would like to order a Rigol DS1052E. Got a few questions.
Is it possible to find the firmware version of the Rigol DS1052E.
That would be very important to me.
--- End quote ---

--- Quote from: crippled ---You'll get 02.05
--- End quote ---

There's no known hack for the 2.05 version of the firmware, right? (we can't downgrade the firmware and hack and then upgrade again, can we?).
Crippled:
Yes, i am :)
I had to wait a while because they had to order from the supplier, so I guess they ordered from rigol, thus the firmware will be 02.05, still unhackable.

I wonder if there are bare jtag pins on the pcb?
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod