General > General Technical Chat

The Rigol DS1052E

<< < (154/166) > >>

Dago:

--- Quote from: mxmxmx on December 14, 2010, 08:43:32 am ---
--- Quote from: Dago on December 13, 2010, 01:41:33 pm ---Can anyone give me any pointers on how to use the ":WAVEFORM:POINTS:MODE MAXIMUM" mode?

I've tried this (in code): stop the scope -> set ":WAVEFORM:POINTS:MODE MAXIMUM" mode -> run scope -> wait for trigger status change to triggered -> stop scope -> get data. But I still get just 600 points of data. What am I doing wrong?

--- End quote ---

Use the single shot mode.

--- End quote ---

I just figured out this myself but thanks :)

n3wbie:
Does this 50 to 100MHz hack still work with the newer Rigol? DS1052E's?

Crippled:

--- Quote from: n3wbie on December 14, 2010, 03:43:09 pm ---Does this 50 to 100MHz hack still work with the newer Rigol? DS1052E's?

--- End quote ---
I ordered mine December 1st at DX, when I receive it, I'll place it here if it is possible to hack or has the 02.05 version.

n3wbie:
Are you the same "Crippled" as on the dx forum?

http://www.dealextreme.com/forums/Forums.dx/Forum.-202~threadid.764985


--- Quote from: NAND74 ---I would like to order a Rigol DS1052E. Got a few questions.
Is it possible to find the firmware version of the Rigol DS1052E.
That would be very important to me.
--- End quote ---

--- Quote from: crippled ---You'll get 02.05
--- End quote ---

There's no known hack for the 2.05 version of the firmware, right? (we can't downgrade the firmware and hack and then upgrade again, can we?).

Crippled:
Yes, i am :)
I had to wait a while because they had to order from the supplier, so I guess they ordered from rigol, thus the firmware will be 02.05, still unhackable.

I wonder if there are bare jtag pins on the pcb?

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod