General > General Technical Chat

Transmitting low bandwith data through long, non-ideal cables

<< < (3/3)

2N3055:

--- Quote from: tggzzz on March 10, 2021, 01:24:19 pm ---You would be wise to consider failure modes including (but not limited to)...

Any equipment on each end is connected to a different phase.

There is a difference in the ground/earth/line voltages at each end, especially if there is a line fault or lightning strike.

Somebody puts a shovel through the cable, and shorts conductors.

Insulation resistance between conductors when water has crept into the cable.

--- End quote ---

Absolutely good thinking, hence my recommendation to use commercial optically isolated converters....

kripton2035:
may be you could also get rid of the cable and use a lora network ?

Navigation

[0] Message Index

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod