General > General Technical Chat
Underlayment plywood + vinyl plank over carpet for an electronics lab
<< < (3/3)
matthuszagh:
Yeah, maybe I just need to accept that carpet isn’t the end of the world and I can address ESD concerns on their own. But there are other reasons I didn’t mention. For instance, my chair is on casters and I don’t know how I’d wheel that around. I guess I could put that on a small section of plywood but I imagine one section will tend to drift around (or always in one direction).

Another reason is my office tends to accumulate dust quickly. I think the reason for this is some combination of me spending a lot of time in there and lots of stuff and equipment in the room. It’s so much easier for me to keep hardwood clean than carpet.
Navigation
Message Index
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod