General > General Technical Chat

Underlayment plywood + vinyl plank over carpet for an electronics lab

<< < (3/3)

matthuszagh:
Yeah, maybe I just need to accept that carpet isn’t the end of the world and I can address ESD concerns on their own. But there are other reasons I didn’t mention. For instance, my chair is on casters and I don’t know how I’d wheel that around. I guess I could put that on a small section of plywood but I imagine one section will tend to drift around (or always in one direction).

Another reason is my office tends to accumulate dust quickly. I think the reason for this is some combination of me spending a lot of time in there and lots of stuff and equipment in the room. It’s so much easier for me to keep hardwood clean than carpet.

Navigation

[0] Message Index

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod