General > General Technical Chat
What happend to 320K resistors ?
<< < (3/27) > >>
Jan Audio:
Ofcourse i want the precision for a DAC,
because i could buy them some time ago i dont want those 316K.
They just disapear ?, someone has buyed them since they have nothing left.
Why not make a few to keep stock ?, is it so difficult ?
bdunham7:
Exactly what were you buying before that you can't get now?  Are the ones I posted not what you need???  Other than '320K' what are the rest of the specs you need or had?
JohnnyMalaria:

--- Quote from: Jan Audio on February 19, 2021, 04:09:40 pm ---Ofcourse i want the precision for a DAC,
because i could buy them some time ago i dont want those 316K.
They just disapear ?, someone has buyed them since they have nothing left.
Why not make a few to keep stock ?, is it so difficult ?

--- End quote ---

Mouser has them. Granted, it's overseas but you have a very specific requirement so your options are going to be limited.

Alternatively, buy a lot of 10% or 20% 330K and measure each one. One will be 320K.
nali:

--- Quote from: Jan Audio on February 19, 2021, 04:09:40 pm ---Ofcourse i want the precision for a DAC,
because i could buy them some time ago i dont want those 316K.
They just disapear ?, someone has buyed them since they have nothing left.
Why not make a few to keep stock ?, is it so difficult ?

--- End quote ---

Just wondering, why do you need such precision when you only have 6 bits anyway?
Siwastaja:
What's wrong with the classic R2R DAC that uses a single value of resistor?

What's wrong in putting another resistor in series?

How are you driving your resistor DAC? From standard CMOS outputs of an MCU or logic IC?  :popcorn:

I think the problem isn't sourcing 320kOhm resistors; it's designing a DAC. Let's start by defining your requirements for the DAC.
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod