General > General Technical Chat
What tool for pot nut?
<< < (4/7) > >>
ChristofferB:
I usually jam each jaw tip of some needle nose pliers in each slot and get it to turn that way.

70% success rate
30% chance it slips and pinches a fingie
120% chance the nut will be unsalvageable, ugly or both.
veedub565:
Many thanks for all the replies, I didn't even know what to search for to begin with but plenty to go at now :)

 
MadTux:
My version of that tool ;-)
With a outside tube, the tool won't slip out of the slot in the nut.
bob91343:
The difficult part is finding a metal tube of the appropriate dimensions.
MadTux:
A lathe and a big metal scrap bin is very helpful in these cases ;-)
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod