General > General Technical Chat

What tool for pot nut?

<< < (4/7) > >>

ChristofferB:
I usually jam each jaw tip of some needle nose pliers in each slot and get it to turn that way.

70% success rate
30% chance it slips and pinches a fingie
120% chance the nut will be unsalvageable, ugly or both.

veedub565:
Many thanks for all the replies, I didn't even know what to search for to begin with but plenty to go at now :)

 

MadTux:
My version of that tool ;-)
With a outside tube, the tool won't slip out of the slot in the nut.

bob91343:
The difficult part is finding a metal tube of the appropriate dimensions.

MadTux:
A lathe and a big metal scrap bin is very helpful in these cases ;-)

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod