General > General Technical Chat

What tool for pot nut?

(1/7) > >>

veedub565:
Hi, what tool do I need to undo this potentiometer nut (pic attached)

I tried long nose pliers and they don't really fit too well, plus its very tight.

tooki:
It’ll likely be a custom tool from the pot manufacturer. But it’s just a pipe with two areas milled off, should you happen to have access to a shop.

Tomorokoshi:
Normally I would use a "circlip" tool. If you do, be careful about the torque, although the tips are usually hardened. There are couple different styles out there.

mikeselectricstuff:
https://www.amazon.co.uk/CruzTools-GTJPT1-Jack-Pot-Tool/dp/B004RMCBCW/ref=asc_df_B004RMCBCW/?tag=googshopuk-21&linkCode=df0&hvadid=310810391039&hvpos=&hvnetw=g&hvrand=12725698364627171831&hvpone=&hvptwo=&hvqmt=&hvdev=m&hvdvcmdl=&hvlocint=&hvlocphy=9044937&hvtargid=pla-564184771629&psc=1&th=1&psc=1#

tooki:

--- Quote from: mikeselectricstuff on October 09, 2020, 03:38:18 pm ---https://www.amazon.co.uk/CruzTools-GTJPT1-Jack-Pot-Tool/dp/B004RMCBCW/ref=asc_df_B004RMCBCW/?tag=googshopuk-21&linkCode=df0&hvadid=310810391039&hvpos=&hvnetw=g&hvrand=12725698364627171831&hvpone=&hvptwo=&hvqmt=&hvdev=m&hvdvcmdl=&hvlocint=&hvlocphy=9044937&hvtargid=pla-564184771629&psc=1&th=1&psc=1#

--- End quote ---
Methinks you didn’t look at the picture of the nut, because that tool is for hex nuts, which aren’t what’s used here.

Navigation

[0] Message Index

[#] Next page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod