General > General Technical Chat
Which type of lead-free solder is the best?
<< < (8/8)
SiliconWizard:

--- Quote from: ebastler on August 18, 2020, 11:16:09 am ---
--- Quote from: peter-h on August 18, 2020, 09:10:58 am ---Military and medical still have exemptions. In fact I think the whole "control and monitoring equipment" exemption may still be there; if not then it ended quite recently. A huge raft of small manufacturers were operating under that. And if you are using up old component stock then you have to because the pins can be tin/lead plated.

--- End quote ---

RoHS exemptions for medical equipment ended in 2016,

--- End quote ---

Active implantable medical devices are still exempted, though.
SiliconWizard:
For manual SMD assembly, I mostly use Multicore 3C, 0.23mm. I use thicker wire (0.6mm) only for the larger parts/wiring/etc.
Calambres:

--- Quote from: peter-h on August 18, 2020, 09:10:58 am ---Military and medical still have exemptions...
--- End quote ---

...and AeroSpace. Otherwise flying airliners would be a no-no for me  :phew:
Navigation
Message Index
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod