General > General Technical Chat
Wire over ethernet
EPAIII:
I don't understand why you wouldn't use an Arduino or Raspberry Pi or just a plain PIC. Once you start two of them talking to each other any data, including very low frequency data or analog signal input with an ADC could be transmitted and reconstituted at the other end. A simple relay could activate a light bulb, buzzer, or bell.
PlainName:
--- Quote from: EPAIII on March 30, 2024, 03:27:56 pm ---I don't understand why you wouldn't use an Arduino or Raspberry Pi or just a plain PIC. Once you start two of them talking to each other any data, including very low frequency data or analog signal input with an ADC could be transmitted and reconstituted at the other end.
--- End quote ---
Perhaps I could highlight a sentence from the post previous to yours:
--- Quote --- I was going to get started on DIY but then wondered if I would just be reinventing some product that already exists.
--- End quote ---
For 'DIY' assume PIC, Pi, whatever (deffo not Arduino though).
Navigation
[0] Message Index
[*] Previous page
Go to full version