General > General Technical Chat
X-ray inspection
(1/2) > >>
IconicPCB:
I am considering getting an Xray inspection unit.
I am worried the unit performance might be a bit mediocre as it employs a source with a 100um target ( source of X ray radiation) at 60KV.

Any opinions and comments?
mikeselectricstuff:
What exactly are you wanting to inspect?
TimFox:
Such a tube is used with geometric magnification of an object close to the tube, and a flat-plate or film far from the object.
Tubes with larger tube targets are used at low magnification, with the object close to the film.
An older reference on radiography:
https://www.glaciermedicaled.com/courses/301/07_Technique_Factors.htm
IconicPCB:
Mike,

solder joints.

Tim,

Thank You.
Always good to learn something new.

I can not comment on the tube to test object distance other than to say the distance is in the 20 to 30mm range.
X-Ray Flat sensor image resolution: 2.1million pixels, 18lp/mm, pixels size:
18um
Effective detect image area and format: 30*30mm

This all sounds clever and vaguely right but what can I expect?


IconicPCB:
no takers?
Navigation
Message Index
Next page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod