Electronics > Circuit Studio
[SOLVED] Design Rules not pushing through to PCB
(1/1)
negativ3:
Hi all,
I'm trying out CS 1.3 and am following through the tutorial for the Multivibrator.
I am at the point of setting up design rules regarding routing, and have setup track widths as per the tutorial, however when I go to route the board, the tracks for GND and +12V remain at 0.254mm. They should be 0.5mm.
Any idea what I'm doing wrong?
Thanks
Andy
negativ3:
Put my binoculars on and found the issue.
Please stand down.
Thanks
Andy
Navigation
[0] Message Index
Go to full version