Author Topic: [SOLVED] Design Rules not pushing through to PCB  (Read 984 times)

0 Members and 1 Guest are viewing this topic.

Offline negativ3

  • Regular Contributor
  • *
  • Posts: 100
  • Country: th
[SOLVED] Design Rules not pushing through to PCB
« on: December 29, 2016, 02:45:57 pm »
Hi all,

I'm trying out CS 1.3 and am following through the tutorial for the Multivibrator.

I am at the point of setting up design rules regarding routing, and have setup track widths as per the tutorial, however when I go to route the board, the tracks for GND and +12V remain at 0.254mm. They should be 0.5mm.

Any idea what I'm doing wrong?

Thanks
Andy
« Last Edit: December 29, 2016, 03:00:39 pm by negativ3 »
 

Offline negativ3

  • Regular Contributor
  • *
  • Posts: 100
  • Country: th
Re: Design Rules not pushing through to PCB
« Reply #1 on: December 29, 2016, 03:00:18 pm »
Put my binoculars on and found the issue.

Please stand down.

Thanks
Andy
 


Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo
Smf